• Made of grey cast iron. This vice may be used on it's own or with the removable swivel base supplied.
• Angle lock clamping. When tightening the vice, the angled face on the nut transmits it's clamping force both forwards and downwards via a self- aligning spherical segment. The spherical segment locates in a corresponding recess inside the movable jaw preventing the jaw from lifting off the guideway. A small amount of jaw lift is possible depending on the type of work being held.
• A friction reducing thrust ball bearing increases clamping pressure when closing the vice.
• Both ends of the fixed jaw have an M8 threaded hole for mounting a work stop (not included).
• For light work, the capacity of the vice can be increased by mounting the jaw plates on either end of the jaws or even on the top of the moveable jaw. Note: The fixed and moveable jaw holder height may vary. If necessary, pack/shim as required if using the vice in these configurations.
• Supplied with swivel base marked in 1 degree increments, locking handle, 2x T-Bolts and 2x locating keys.

Note: For greater accuracy, an index mark should be scribed on the vice with the swivel base properly located on your milling table with location keys and the fixed jaw clocked square to the table.